Template for Carbon Dioxide Euthanasia of Rodents

Purpose

Rodents must be euthanized by trained personnel using appropriate techniques, equipment and agents. This is necessary to ensure a painless death that satisfies research requirements. Death should be induced as painlessly and quickly as possible. Upon completion of the procedure, death must be confirmed by an appropriate method, such as ascertaining cardiac and respiratory arrest or noting an animal's fixed and dilated pupils. Euthanasia should not be performed in the animal room. The euthanasia method must be appropriate to the species, approved in the animal study proposal and conform to the most recent Report of the AVMA Panel on Euthanasia.

Guidelines

• CO2 inhalation is the most common method of euthanasia used for mice and rats. A few important aspects of this procedure are:

   

  1. The euthanasia chamber should allow ready visibility of the animals. Do not overcrowd the chamber: all animals in the chamber must be able to make normal postural adjustments. Compressed CO2 gas in cylinders is the only recommended source of carbon dioxide as it allows the inflow of gas to the induction chamber to be controlled. Without pre-charging the chamber, place the animal(s) in the chamber and introduce 100% carbon dioxide at the rate of 10% of the chamber volume per minute. (For a 10-liter volume chamber, use a flow rate of approximately 1 liter per minute.) After the animals become unconscious, the flow rate can be increased to minimize the time to death. Sudden exposure of conscious animals to carbon dioxide concentrations of 70% or greater has been shown to be distressful. Animals should be left in the container until clinical death has been ensured.
  2. Neonatal animals (up to 14 days of age) are resistant to the effects of CO2, therefore, alternative methods are recommended. Carbon dioxide may be used for narcosis of neonatal animals provided it is followed by another method of euthanasia (i.e. decapitation using sharp blades).
  3. If an animal is not dead following CO2 exposure, another approved method of euthanasia (e.g. decapitation) must be added while the animal is under CO2 narcosis to assure death.

Template

Animals are euthanized in a chamber permitting observation of them during the euthanasia process. The chamber is connected to a tank of compressed carbon dioxide equipped with a regulator. The carbon dioxide flow rate is adjusted to 10% of the chamber volume per minute until the animals are observed to lose consciousness. After this point a maximal flow rate may be used if desired. Adult rodents are exposed to 100% CO2 for 5+ minutes; preweaning rodents are exposed for 20+ minutes. After CO2 exposure animals are returned to room air and rechecked after 5 minutes. Animals that have revived are reexposed to CO2 or euthanized by another method. Alternatively, a physical method such as decapitation, exsanguination or creation of a pneumothorax may be used immediately after the animals are removed from the CO2 chamber to ensure death.

References

1. Danneman PJ, Stein S, Walshaw SO. Humane and practical implications f using carbon dioxide mixed with oxygen for anesthesia or euthanasia of rats . Lab Anim Sci 1997, 47:376-385.
2. AVMA Panel on Euthanasia. 2000 Report of the AVMA Panel on Euthanasia . J Am Vet Med Assoc 2001, 218:669-696.
3. Guidelines for the Euthanasia of Mouse and Rat Fetuses and Neonates .
4. NIH Animal Research Advisory Committee, 2001 (see web site: http://oacu.od.nih.gov/ARAC/ euthmous.htm).